How to Perform Factory Reset on a Nighthawk Extender?

Are you facing issues while performing Netgear Nighthawk extender setup? Have you lost or forgotten the login password of your Nighthawk extender? Can’t log in to Netgear extender because the web address www.mywifiext.net is not working? Extender connected but no internet? Are these queries boggling your mind? If you nod in yes, then don’t sweat over it. We’ve got you covered!

You can easily resolve all the extender-related issues either by resetting it or updating its firmware. In this piece of writing, we will take you through the effective methods that will help you resolve issues with your Netgear extender. Read on!

How to Reset Netgear Nighthawk Extender?

Before you reset your Nighthawk extender, it is important for you to know that a factory reset erases all the personalized information and data on your Netgear device, including username, login password, and security settings. So, it is recommended to take the backup of all the customized settings of your Netgear Nighthawk extender.

To reset your Netgear Nighthawk extender, follow the instructions highlighted below:

In the first place, verify that your Netgear Nighthawk extender is properly plugged in and receiving continuous power supply.

• Secondly, ensure that no device is connected to your extender’s network, not even your router.
• Also, make sure that the power LED on your Netgear Nighthawk extender is lit and green.
• Then, locate the reset hole on your Netgear Nighthawk extender.
• Now, grab a pin or a paper clip.
• Carefully and gently insert the object into the Netgear extender reset hole.
• Keep holding the reset hole on the Netgear extender till the power LED on it start blinking.
• Release the extender reset hole.
• Fab! Your Netgear extender resets successfully.

Once your device resets successfully, you can now perform the Netgear Nighthawk extender setup process again. As soon as you set up your Netgear Nighthawk extender completely and properly, you can enjoy the ultimate speed of the internet in every nook and cranny of your house, even in those areas where WiFi was never expected.

Another effective method to fix the issues highlighted above is to update Netgear extender firmware to the latest version.

How to Update Netgear Extender Firmware to the Latest Version?

• First things first, place your Netgear Nighthawk extender and your existing router in close proximity.
• After that, turn on your desktop or laptop and launch a web browser of your choice on it.
• Log in to your Netgear extender using www.mywifiext.net. If the web address does not work for you, use the Netgear extender default IP address instead.
• Press Enter to have access over Netgear Nighthawk setup page.
• Select the Settings option and then click on Firmware Update button.
• Check for the updates available for your Netgear Nighthawk extender. And if you find any, get it updated by clicking on the Upload button.

Note: Once you click on the upload button, it is suggested to have patience. The process might take 4-5 minutes. So, do not turn off your Netgear extender or disconnect it from your main router.

Perhaps your current router is not working well. And if you want to take your internet experience to the next level and want to boost your WiFi range up to 40, then add a Nighthawk router to your Netgear extender. For this, simply perform Nighthawk router setup and experience the change yourself.

To Conclude

We hope that after following the tips given in this piece of writing, you will be able to resolve all the extender-related issues. On the off chance if you have any other issue with your device apart from the above-mentioned ones, then let us know your problem in the comments section.